Thomas Turner, Birmingham, Snider
Today I received my Thomas Turner Commercial Snider. It is in wonderful condition. Unfortunately the 24 ga. Magtech brass shotgun shell I trimmed down to 2" will go no farther into the chamber than...
View ArticleRe: Thomas Turner, Birmingham, Snider
I have no experience with the plastic cases, but what you are experiencing with the brass cases is normal. They need to be ran through the FLS die first so they can chamber. After they are fireformed...
View ArticleRe: Thomas Turner, Birmingham, Snider
Have you reformed the brass using a Snider die yet? The Snider chamber is straight walled but usually tapered to some degree. If you don't size the brass down, it probably won't go in very far. The...
View ArticleRe: Thomas Turner, Birmingham, Snider
I do not have a Snider Die or a large enough press to screw it into. A .577 minie ball fits in the muzzle so I don't think I have the 4th rifle. I live in SW Baltimore County, MD 21228 near UMBC....
View ArticleRe: Thomas Turner, Birmingham, Snider
The 24ga brass is very tough. It definitely requires annealing. If you email me your address, I'll send you some 24 ga plastic shells that might solve your problem.
View ArticleRe: Thomas Turner, Birmingham, Snider
"If I can get hold of the proper die and prelube the case before sizing, why must I anneal new brass? " The MagTech brass tends to quite work hardened as it comes from the factory. Annealing is very...
View ArticleRe: Thomas Turner, Birmingham, Snider
Thanks Joel, Again, you have been a great help. I would certainly like to eventually make some properly annealed formed brass shells, but it would be nice to see if the plastic will fit in the...
View ArticleRe: Thomas Turner, Birmingham, Snider
My question to PommyB: I noticed that the interior base of the Magtech brass does not have a built up area around the indented primer hole. Once one has trimmed and formed the Magtech brass,...
View ArticleRe: Thomas Turner, Birmingham, Snider
Various stages to form 24ga to 577 Snider. You can see why trimmed to 2" won't go into the chamber.
View ArticleRe: Thomas Turner, Birmingham, Snider
The MagTech brass cases are referred to as semi-balloonhead, & that is what you are seeing with the raised primer pocket area at the bottom of the case. No, there is no need for a base wad. While...
View ArticleRe: Thomas Turner, Birmingham, Snider
Thank you Wallace. A picture is worth at least 100 words.
View Article
More Pages to Explore .....